details
1. Prepare
First, each guide roller of the base material is installed according to the routing direction, and the adhesive is adjusted in proportion to start the heating system of the oven. When the corresponding set temperature is reached, the transmission motor can be switched on for coating production.
2. The coating
The base material of the rolling device should go through the roller first, after the adhesive coating, and then through the dry bath, that is, the coating process.
3. The composite
The EPC gas-liquid rectifying enters the compound part, and is combined with the base material of the second unwinding part to realize the compound process.
4. Cooling and winding
After the cooling coils are finished, the overall production of the base material is finished.
(1) adjust the smoothness of base material by adjusting the position of deviation roller.
(2) adjust the compound pressure between two compound rollers by adjusting the relative distance between them.
(3) control the traction tension and winding tension of the base material by adjusting the tension clamp of the clutch and brake to make the machine run smoothly, so as to obtain good coating quality and compound effect dry type compound machine.
Recommend information
- 18-09-15Characteristics and application of tape slitter
- 18-09-15Domestic cutting machine development three aspects
- 18-09-15The difference between slitting machine and cross-cutting machine
- 18-09-15Application method of compound machine
- 18-09-15Introduce what is paper cutting machine
- 18-09-15What is the use of paper cutting machine?
- 18-09-15What are the operation requirements of the cutting machine?
- 18-09-15What is the mechanism of the paper cutting machine?
- 18-09-15The operation engineering of compound machine equipment will be explained one by one
- 18-09-15What are the reasons for the brittle seal of the cutting machine? What's the problem?